I'm new to MC Things and received a 205 Demo board from SigFox to test the network and familiarize myself MC Things and SigFox. 

I have installed all the recommended software and am trying to connect my 205 board to the mc-Studio. 

When i open the Devices Menu, i see the following two devices listed 1) 00.00.FF.E0 Virtual Gateway (Connected) and 2) 00.00.FF.C0 Testboard Gateway... i'm not sure what these devices are, but when i plug in my 205 board nothing seems to show up and I can't figure out how to proceed.

When i plug in my board, i see a little red flash and then everything appears off... button presses don't do anything... no difference if running off batter or USB... i do see the board creates a USB Serial Port so i know it is running...

Any thoughts or recommendations would be extremely helpful.

I have been plugging in the board without the blue jumper on.

note that Testboard Gateway shows up in the top menu even before i have plugged in the 205 board. 

When i press "Connect Gateway" an error pops up that says "Found 2 device. Non of the devices is a Test board."

i hit "Ok" and put the blue jumper on, the led flashes on the board a couple times and then nothing happens.

and yes, I've been following the procedure in the user guide with the same result.