Hello.
I have made a simple IR receiver/sender based on BC547, BC557.
For some reason I can't get it to work with a mcModule the IR does not send anything, if I connect it to an arduino then it works.
What is the difference between the pins on arduino and mcModule?
This is not in the code it is something with the connection of hardware between the mcModule and my homemade IR i think.
The connection is only TX,RX,3.3v and GND I am using external power to both mcModule and the IR.
Define PinMode Pin1 As DigitalInput //RX
Define PinMode Pin3 As DigitalOutput //TX
Shared serial As Uart
Shared Event Boot()
serial = Uart.Create(1200, Pin.Pin3, Pin.Pin1)
End Event
Shared Event Send() RaiseEvent Every 10 Seconds
serial.Write(0x80)
serial.Write(0x3f)
serial.Write(0x02)
serial.Write(0x35)
serial.Write(0xe9)
serial.Write(0x0d)
End Event
On the arduino I use SoftwareSerial with same baud (1200).